The Relationship Between Driving Behavior and Entropy

Jeffrey D Dawson; Sarah D Cosman; Yang Lei; Elizabeth Dastrup; JonDavid Sparks

doi:10.17077/drivingassessment.1226

OBJECTIVES High variability in the lateral control of a vehicle may result in an increased likelihood of accidents. Boer (2000) proposed a method of quantifying variability in steering wheel position, termed “entropy” (scaled between 0 and 1). In this approach, the steering wheel position at each time point is predicted based on the position at the three preceding time points, and the discrepancies between the predicted and observed values are utilized to define a baseline distribution of prediction errors within a subject. This distribution is then used as a reference for calculating a summary “entropy” metric in follow-up segments of driving, such as when a driver may be distracted when using a cell phone. This same concept has also been applied to the lateral position of a vehicle (Dawson et al., 2006). The objective of this study was to ascertain whether entropy was affected by behavioral factors such as steering techniques and speed. We hoped to gain insight regarding the usefulness of entropy measures, and the appropriate interpretation of statistical tests based on entropy. METHODS We designed a simple driving route in a simulator known as SIREN (Rizzo, 2004), with a straight road segment of 3.7 km, followed by an S-curved road segment of 3.8 km. Using an expert driver familiar with the simulator, we performed a factorial experiment with different steering techniques (normal driving, swerving, and steering using a rigid grip and sudden “jerks”) and driving speeds (35 mph, 55 mph, and 75 mph). Data on steering wheel position and lane position were collected at 30 frames per second, and then reduced to 5-frame blocks of 167 msec each. Based on these blocks, we estimated the baseline parameter to characterize the prediction errors for each drive during the straight road section, and then applied this parameter to the straight and curved road sections in order to calculate entropy. This approach was used for both steering and lane position entropy. The data were analyzed using multiple linear regresssion to assess the affects of steering technique and speed, adjusting for road curvature. We also calculated Pearson correlation coefficients to measure the association between steering and lane position entropy. RESULTS Data were obtained on a total of 40 drive segments. Steering entropy ranged from 0.34 to 0.90, with a mean (SD) of 0.56 (0.16). Lane position entropy ranged from 0.34 to 0.93, with a mean (SD) of 0.61 (0.15). Compared to normal driving, steering behavior involving jerking motions tended to lower the steering entropy by 0.14 (p=0.012), and tended to lower the lane position entropy by 0.25 (p<0.001). Swerving in wide lateral motions had no effect on steering entropy, and only a minor effect on lane position entropy, decreasing it by 0.07. Compared to driving at 35 mph, driving at either 55 mph or 75 mph increased the steering entropy by an average of 0.08, but had no effect on lane position entropy. Although not our primary focus, we found that driving in curved sections tended to have higher entropy measures (increase of 0.21 for steering and 0.20 for lane position; p<0.001 in both cases). Despite a few outliers, the correlation between steering and lane position entropy was found to be high (r=0.84; see Figure 1). CONCLUSIONS Although entropy is often considered as an increasing function of workload, and would presumably increase in non-optimal conditions, some unsafe driving behaviors are actually negatively associated with entropy. Safe driving often involves making frequent minor steering adjustments, especially in curved sections of the road, which might lead to an increase in the entropy measure. If a driver rigidly holds onto the steering wheel and then makes large corrections when approaching or crossing a lane boundary, the fixed steering wheel position over several seconds may actually cause an apparent decrease in entropy. In summary, entropy may be a useful tool in quantifying vehicular control, but caution should be exercised when interpreting the results, as the associations involving entropy are not always in the anticipated direction.

The Relationship Between Driving Behavior and Entropy

Files and links (1)

Abstract

Details

Metrics