Journal article
Characterization and Mapping of Very Fine Particles in an Engine Machining and Assembly Facility
Journal of occupational and environmental hygiene, Vol.4(5), pp.341-351
03/26/2007
DOI: 10.1080/15459620701290081
PMID: 17454502
Abstract
Very fine particle number and mass concentrations were mapped in an engine machining and assembly facility in the winter and summer. A condensation particle counter (CPC) was used to measure particle number concentrations in the 0.01 μ m to 1 μ m range, and an optical particle counter (OPC) was used to measure particle number concentrations in 15 channels between 0.3 μ m and 20 μ m. The OPC measurements were used to estimate the respirable mass concentration. Very fine particle number concentrations were estimated by subtracting the OPC particle number concentrations from 0.3 μ m to 1 μ m from the CPC number concentrations. At specific locations during the summer visit, an electrical low pressure impactor was used to measure particle size distribution from 0.07 μ m to 10 μ m in 12 channels. The geometric mean ratio of respirable mass concentration estimated from the OPC to the gravimetrically measured mass concentration was 0.66 with a geometric standard deviation of 1.5. Very fine particle number concentrations in winter were substantially greater where direct-fire natural gas heaters were operated (7.5 × 10
5
particles/cm
3
) than where steam was used for heat (3 × 10
5
particles/cm
3
). During summer when heaters were off, the very fine particle number concentrations were below 10
5
particles/cm
3
, regardless of location. Elevated very fine particle number concentrations were associated with machining operations with poor enclosures. Whereas respirable mass concentrations did not vary noticeably with season, they were greater in areas with poorly fitting enclosures (0.12 mg/m
3
) than in areas where state-of-the-art enclosures were used (0.03 mg/m
3
). These differences were attributed to metalworking fluid mist that escaped from poorly fitting enclosures. Particles generated from direct-fire natural gas heater operation were very small, with a number size distribution modal diameter of less than 0.023 μ m. Aerosols generated by machining operations had number size distributions modes in the 0.023 μ m to 0.1 μ m range. However, multiple modes in the mass size distributions estimated from OPC measurements occurred in the 2-20 μ m range. Although elevated, very fine particle concentrations and respirable mass concentrations were both associated with poorly enclosed machining operations; the operation of the direct-fire natural gas heaters resulted in the greatest very fine particle concentrations without elevating the respirable mass concentration. These results suggest that respirable mass concentration may not be an adequate indicator for very fine particle exposure.
Details
- Title: Subtitle
- Characterization and Mapping of Very Fine Particles in an Engine Machining and Assembly Facility
- Creators
- William A Heitbrink - Department of Occupational and Environmental Health , University of IowaDouglas E Evans - National Institute for Occupational Safety and Health, Division of Applied Research and TechnologyThomas M Peters - Department of Occupational and Environmental Health , University of IowaThomas J Slavin - International Truck and Engine Corporation
- Resource Type
- Journal article
- Publication Details
- Journal of occupational and environmental hygiene, Vol.4(5), pp.341-351
- Publisher
- Taylor & Francis Group
- DOI
- 10.1080/15459620701290081
- PMID
- 17454502
- ISSN
- 1545-9624
- eISSN
- 1545-9632
- Language
- English
- Date published
- 03/26/2007
- Academic Unit
- Roy J. Carver Department of Biomedical Engineering; Occupational and Environmental Health
- Record Identifier
- 9983997342102771
Metrics
23 Record Views