Journal article
Influence of Veneering Fabrication Techniques and Gas-Phase Fluorination on Bond Strength between Zirconia and Veneering Ceramics
Journal of prosthodontics, Vol.25(6), pp.478-484
08/2016
DOI: 10.1111/jopr.12451
PMID: 26849102
Abstract
Porcelain chipping has been one of the main problems of porcelain-fused-to-zirconia restorations. This study evaluates the bond strengths of layered, pressed, and adhesively bonded porcelain to yttria-stabilized zirconia substrates that have undergone traditional preparation or gas-phase fluorination.
A three-point bending test was used to evaluate the bond strength of the porcelain and zirconia interface. Sixty-six specimens were prepared (n = 11) following ISO 9693 and loaded until failure using an Instron testing machine. One-half of the zirconia substrates received gas phase fluorination treatment before veneering application. Three porcelain veneering methods were evaluated: layered, pressed, and adhesively bonded porcelain. Bond strength results were interpreted using a two-way ANOVA and a Bonferroni multiple comparisons test. Statistical significance was set at α = 0.05.
ANOVA revealed a statistically significant effect of the veneering fabrication methods. No main effect was observed regarding the surface treatment to the zirconia. There was a significant effect related to the veneering method used to apply porcelain to zirconia. For untreated zirconia, layered porcelain had a significantly higher flexural strength compared to pressed or bonded, while pressed and bonded porcelains were not significantly different from one another. For zirconia specimens receiving fluorination treatment, both layered and pressed porcelains had significantly higher bond strengths than adhesively bonded porcelain. In addition, fluorinated pressed porcelain was not statistically different from the control layered or fluorinated layered porcelain.
The choice of veneering fabrication technique was critical when evaluating the zirconia to porcelain interfacial bond strength. Bonded porcelain to zirconia had a lower flexural strength than layered or pressed porcelain, regardless of zirconia surface treatment. In addition, fluorination had an effect on the bond strength of pressed porcelain.
Details
- Title: Subtitle
- Influence of Veneering Fabrication Techniques and Gas-Phase Fluorination on Bond Strength between Zirconia and Veneering Ceramics
- Creators
- Stewart W Pharr - Private Practice, Austin, TXErica C Teixeira - Department of Operative Dentistry, University of Iowa, Iowa City, IARonald Verrett - Department of Comprehensive Dentistry, University of Texas Health Science Center, San Antonio, TXJeffrey R Piascik - RTI International, Center for Materials and Electronic Technologies, Durham, NC
- Resource Type
- Journal article
- Publication Details
- Journal of prosthodontics, Vol.25(6), pp.478-484
- Publisher
- United States
- DOI
- 10.1111/jopr.12451
- PMID
- 26849102
- ISSN
- 1059-941X
- eISSN
- 1532-849X
- Language
- English
- Date published
- 08/2016
- Academic Unit
- Operative Dentistry
- Record Identifier
- 9984066094802771
Metrics
25 Record Views